AMX NXT-CV7, NXD-CV7 instruction manual Installation

Installation

3 notches are required to accommodate the three expansion clips (included)

Install the 3 included drywall clip sets into these locations

A - Faceplate /Trim Ring

Drywall Clip (3)

Mounting Tab

B - Main NXD unit consists of the touch panel and back box

FIG. 37 Wall Mount panel (NXD) installation configuration for drywall surfaces

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the drywall.

6.Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify the panel is receiving power and functioning properly to prevent repetition of the installation.

7.Disconnect the terminal end of the power cable from the connected PSN power supply.

8.Install the three sets of drywall screws and expansion clips into the three oval notch locations along both sides of the main unit (B in FIG. 37).

9.Carefully insert the main unit (with expansion clips) into the cutout until the Mounting Tabs on the NXD unit lie flush against the wall.

The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed during a re-installation.

10.Tighten all three drywall clip sets (screws and clips) until the entire Mounting Tab is securely fastened and flush against the wall.

11.Place the Faceplate (A in FIG. 37) back onto the main NXD unit (B in FIG. 37). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front faceplate/bezel.

7" Modero Widescreen Touch Panels 37