AMX NXD-CV7 Closing and Securing the NXT Enclosure, Removing/installing a compact flash card

CV7 Touch Panel Accessories

6.Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push it in firmly until the contact pins are completely inside the flash card and securely attached to the connector.

Card removal grooves

On-board connector with contact pins

Insert with arrow facing towards the pins

Connector opening

FIG. 19 Removing/installing a compact flash card

7.Repeat steps 3-6 for installation of the (optional) NXA-WC80211B/CF 802.11b wireless interface card into the remaining open card slot.

Any new internal card upgrade is detected by the panel only after power is cycled.

Step 3: Closing and Securing the NXT Enclosure

1.In a single motion, gently slide the rear Tilt Bracket cover plate back over the tilt mechanism (located below the LCD) and (while angling the housing downwards) slide the outer housing below the Tilt Bracket and towards the LCD (at a downward angle).

2.Locate the two screw holes at either sides of the front speaker grill.

3.Use a grounded Phillips-head screwdriver to both insert and secure the two Tilt Bracket Screws (FIG. 16). This procedure resecures the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets).

4.Press the outer housing forwards until it is aligned over the outer housing installation holes. Once installed and secured, the tilt bracket prevents any further movement (FIG. 17).

5.Gently press down on the housing (toward the base) until it is securely positioned over the circuit board and base.

6.While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown on a soft cloth and the under-side of the base is exposed.

7.Insert and secure the four Housing Screws (using a grounded Phillips-head screwdriver) in their respective locations, as shown in FIG. 15 on page 16.

8.Replace any adhesive plastic "feet" that might have been removed during the removal process of the outer housing. These "feet" must be placed back onto their original locations so they can fit into their provided openings on the Battery Base.

18 7" Modero Widescreen Touch Panels