Installation

12.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

13.Reconnect the terminal power connector on the PSN and apply power to the panel.

Installing the NXD into a Flat Surface using #4 screws

Mounting screws (#4-40, included) are secured through two sets of circular holes located at the left and right sides of the NXD-CV7. The most important thing to remember when mounting the NXD Wall Mount is that the outer frame (Mounting Tabs) must be installed flush against the mounting surface.

Refer to SP-2258-01for detailed installation dimensions (reproduced in FIG. 38).

It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

1.Remove any screws or nails from the surface before beginning the cutout process.

2.Cut out the surface for the NXD Wall Mount unit using the dimensions shown in FIG. 38.

FIG. 38 NXD-CV7 Wall Mount panel dimensions using #4-40 mounting screws

3.Remove the Faceplate/bezel (A in FIG. 39) from the main NXD unit (B in FIG. 39) by gripping the faceplate and pulling with gentle outward force.

 

38

7" Modero Widescreen Touch Panels

 

 

 

Page 46
Image 46
AMX NXD-CV7, NXT-CV7 instruction manual Installing the NXD into a Flat Surface using #4 screws