AMX NXD-CV7, NXT-CV7 instruction manual Panel Calibration

Table of Contents
Installation	29
Unpacking the Panel	29
Installing the Internal Components	29
Installing the No-Button Trim Ring	29
Installing the Button Trim Ring	31
Pre-Wall Installation of the Conduit Box	33
Installation of an NXD Touch Panel	34
Installing the NXD panel within a Conduit Box	34
Installing the NXD into drywall using Expansion Clips	35
Installing the NXD into a Flat Surface using #4 screws	38
Installing an NXD-CV7 into an (optional) Rack Mount Kit (NXA-RK7)	40
Wiring Guidelines for the CV7 Panels	41
Preparing captive wires	41
Using the PSN NetLinx connector for power	41
Audio/Video RJ-45 Connections and Wiring	42
Ethernet 10/100 Base-TRJ-45 Connections and Wiring	42
Connecting and Using USB Input Devices	43
Panel Calibration	45
Calibrating the Modero Panel	45
Testing your Calibration	46
Configuring Communication	47
Modero Setup and System Connection	47
Configuring and Using USB with a Virtual Master	49
Step 1: Setup the Panel and PC for USB Communication	49
Step 2: Confirm the Installation of the USB Driver on the PC	49
Step 3: Confirm and View the current AMX USB device connections	51
Step 4: Use the USB to Configure a Virtual Master (using NetLinx Studio)	53
Step 5: Confirm and View the current AMX USB device connections	54
Secondary Connection Page - Wireless Access Overview	55
IP Routing	55
Hot Swapping	55
Configuring a Wireless Network Access	57
Step 1: Configure the Panel’s Wireless IP Settings	57
Wireless communication using a DHCP Address	57
Wireless communication using a Static IP Address	58
Step 2: Configure the Card’s Wireless Security Settings	59
Configuring the Modero’s wireless card for unsecured access to a WAP200G	59
Configuring the Modero’s wireless card for secured access to a WAP200G	60
Configuring multiple wireless Moderos to communicate to a target WAP200G	64

ii 7" Modero Widescreen Touch Panels