Configuring Communication

Obtained

from

NetLinx

Master

FIG. 61 System Connection page

Master Connection section - Virtual Master communication over Ethernet

When configuring your panel to communicate with a Virtual Master (on your PC) via Ethernet, the Master IP/URL field must be configured to match the IP Address of the PC and make sure to use the Virtual System value assigned to the Virtual Master within NetLinx Studio.

Before beginning:

1.Verify the panel has been configured to communicate either through an Ethernet cable (connected from either the panel to a valid Ethernet Hub) or wireless to the Wireless Access Point.

2.Launch NetLinx Studio 2.3 (default location is Start > Programs > AMX Control Disc > NetLinx Studio > NetLinx Studio 2.3).

3.Select Settings > Master Communication Settings, from the Main menu to open the Master Communication Settings dialog (FIG. 62).

Enter this IP into the Master IP/URL field on the

System Connection page

IP Addresses of computer (also obtained by using the Start > Run > cmd command)

FIG. 62 Assigning Communication Settings and TCP/IP Settings for a Virtual Master

4.Click the Communications Settings button to open the Communications Settings dialog.

7" Modero Widescreen Touch Panels

67

 

 

 

 

Page 75
Image 75
AMX NXT-CV7, NXD-CV7 instruction manual Obtained From NetLinx Master