AMX NXT-CV7, NXD-CV7 instruction manual Installation of the Wireless Card WallMount Panel

CV7 Touch Panel Accessories

9.Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.

10.Insert all connectors and apply power.

Installation of the Wireless Card (WallMount Panel)

These procedures involve removing the outer housing, installing the wireless card, and then securely replacing the outer housing back onto the NXD panel.

The CV7 panels do not come factory installed with the NXA-WC802.11B/CF wireless

interface card. This card must be ordered separately from AMX.

Step 1: Removing the existing NXD Outer Housing

1.Detach all connectors from the side of the touch panel.

2.Remove the faceplate from the CV7.

3.Place the LCD facedown on a soft cloth to expose the under-side of the unit (FIG. 20) and prevent scratching of the LCD.

Two (2) connector overlay release latches

Unscrew these four pan-head housing screws to remove the back box (2 per side)

FIG. 20 Location of the attachment screws and connector overlay release latches on an NXD back box

4.Firmly press down on both connector overlay release latches (located in front of the connectors). Pressing down releases the connector overlay from atop the connectors.

The overlay connector must first be released before the rear back box can be removed from the NXD-CV7 panel.

5.Gently slide the connector overlay away from the back box housing.

6.Unscrew the outer housing (back box) by using a grounded Phillips-head screwdriver to remove the two sets of pan-head Housing Screws, located on other side of the connector overlay (FIG. 20).

7" Modero Widescreen Touch Panels 19