AMX NXT-CV7, NXD-CV7 instruction manual Along the edges

Installation

4.Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from their terminal sources) through the surface opening. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

5.Connect all data and power wiring connectors to their corresponding locations along the left side of the (un-powered) NXD touch panel.

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before being inserted into the solid surface.

6.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify that the panel is receiving power and functioning properly before finalizing the installation.

	Attachment is done
	along the edges
Flat installation surface	of the cutout

Install the four #4-40 Mounting Screws (included) into these four holes

Mounting Tab

B - Main CV7 unit

A - Faceplate/Trim Ring

FIG. 39 Wall Mount panel installation configuration for flat surfaces

7.Disconnect the terminal end of the power cable from the power supply.

8.Carefully slide the main unit into the cutout until the Mounting Tabs of the CV7 unit lie flush against the wall.

7" Modero Widescreen Touch Panels 39