AMX NXT-CV7 BRD-vt addr range,button states range,border Name, BSF-vt addr range,selection value

	Programming
"^" Button Commands (Cont.)
^BRD	Only if the specified border is not the same as the current border. The border names are
Set the border of	available through the TPDesign4 border-name drop-down list.
a button state/	Syntax:
states.	"'^BRD-<vt addr range>,<button states range>,<border
	name>'"
	Variable:
	variable text address range = 1 - 4000.
	button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	border name = Refer to Border Styles and Programming Numbers table on page 122.
	Example:
	SEND_COMMAND Panel,"'^BRD-500.504&510.515,1&2,Quad Line'"
	Sets the border by name (Quad Line) to those buttons with the variable text range of
	500-504 & 510-515.
	Refer to the TPD4 Border Styles by Name table on page 122.
^BSF	Note: Select one button at a time (single variable text address). Do not assign a variable
Set the focus to	text address range to set focus to multiple buttons. Only one variable text address can be
	in focus at a time.
the text area.
	Syntax:
	"'^BSF-<vt addr range>,<selection value>'"
	Variable:
	variable text address range = 1 - 4000.
	selection value = Unselect = 0 and select = 1.
	Example:
	SEND_COMMAND Panel,"'^BSF-500,1'"
	Sets the focus to the text area of the button.
^BSM	This command causes the text areas to send their text as strings to the NetLinx Master.
Submit text for	Syntax:
text area buttons.	"'^BSM-<vt addr range>'"
	Variable:
	variable text address range = 1 - 4000.
	Example:
	SEND_COMMAND Panel,"'^BSM-500'"
	Submits the text of the text area button.
^BSO	If the sound name is blank the sound is then cleared. If the sound name is not matched,
Set the sound	the button sound is not changed.
played when a	Syntax:
button is pressed.	"'^BSO-<vt addr range>,<button states range>,<sound
	name>'"
	Variable:
	variable text address range = 1 - 4000.
	button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	sound name = (blank - sound cleared, not matched - button sound not changed).
	Example:
	SEND_COMMAND Panel,"'^BSO-500,1&2,music.wav'"
	Assigns the sound 'music.wav' to the button Off/On states.

7" Modero Widescreen Touch Panels 135