AMX NXD-CV7 instruction manual Installing the NXA-BASE/1 below an NXT-CV7 Panel, Back

CV7 Touch Panel Accessories

3.Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector Port.

Installing the NXA-BASE/1 below an NXT-CV7 Panel

1.Power Off the panel before attempting to attach the NXA-BASE/1.

2.Place the battery base (with battery) onto a flat/level surface.

3.Turn the battery locking slider (FIG. 26) to one side until the locking mechanism is horizontal to the base (going left to right) and the rear battery latch is pointing directly outward (away from the LCD).

Alignment	Back	Battery
pegs (2)		locking
Panel Interface		mechanism
connector (male)

Battery locking slider

(Battery not shown

for illustration purposes)

Front

Insert holes for

NXT-CV7 feet

Securing pegs (2)

FIG. 26 NXA-BASE/1 showing Panel Interface and connector locations

4.Carefully angle the NXT-CV7 panel over the front alignment pegs (FIG. 27). The pegs assist in both aligning and securing the panel to the base (the locking mechanism secures the base to panel when done).

	Battery
	locking
	mechanism
Alignment	(with locking
	slider)
pegs

FIG. 27 NXA-BASE/1 shown aligning with NXT-CV7 panel

5.Insert the alignment pegs into their corresponding holes below the front of the panel.

6.Verify the alignment of the Panel Interface connectors between the panel (female connector) and base (male connector) (FIG. 27).

24 7" Modero Widescreen Touch Panels