AMX NXT-CV7, NXD-CV7 Installing the Button Trim Ring, Inserting the No-Button Trim Ring

Installation

No-Button Trim Ring

Hollow button openings

Faceplate (outer surface shown)

FIG. 31 Inserting the No-Button Trim Ring

Installing the Button Trim Ring

The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to re-install the Button Trim Ring back onto an NXD panel which has had the default Button Trim Ring features removed; you must first remove the No-Button Trim Ring:

1.To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2.Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.

3.In a single motion, press down and then outwards on the three Trim Ring latches located along the top of the internal surface of the Faceplate to begin removing the Trim Ring. Removing the Internal Faceplate from the panel exposes the pushbuttons openings left from an earlier removal of the pushbuttons and LEDs.

4.Gently tug along the edges of the No-Button Trim Ring and work your way around the edges to remove it from the Faceplate (FIG. 32).

5.From along the internal surface of the Faceplate, install the six buttons by firmly inserting them into the button openings until the Button latch secures the button in place (FIG. 32).

6.Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe latches.

7.Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the Faceplate (made available by the removal of the previous Trim Ring).

7" Modero Widescreen Touch Panels 31