AMX NXT-CV7, NXD-CV7 instruction manual Configure the Card’s Wireless Security Settings

Configuring Communication

Step 2: Configure the Card’s Wireless Security Settings

The second step to successfully setting up your wireless card is to configure the Wireless Settings section of the Secondary Connection page. The section configures both the communication and security parameters from the internal wireless card to the WAP. The procedures outlined within the

following sections use an NXA-WAP200G and the target WAP.

Once you have completed setting up the wireless card parameters, you must then navigate to the System Connection page and configure the communication parameters for the target Master. Until those parameters are configured, your Connection Status icon will remain red (indicating that there is no current connection to a Master).

Configuring the Modero’s wireless card for unsecured access to a WAP200G

Prior to beginning the configuration of the wireless settings, verify that the panel has been upgraded to a wireless panel via the installation of the NXA-WC80211B/CF wireless interface card.

1.Power-down the Modero unit and follow the wireless card installation procedures outlined in the Installation of the Wireless Card (Table Top Panel) section on page 15.

2.Power-up the panel (this allows it to detect the card).

3.Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display an on-screen keypad.

4.Enter 1988 into the Keypad’s password field and press Done when finished.

5.Press the Secondary Connection button (located on the lower-left) to open the Secondary Connection page.

6.From within the Wireless Settings section of the Secondary Connection page, touch the Network Name (SSID) field (FIG. 57).

Wireless card settings

FIG. 57 Secondary Connection page (showing default values)

7.From the Service Set Identifier keyboard, enter the SSID name used on your target Wireless Access Point (case sensitive).

The card should be given the SSID used by the target WAP. If this field is left blank, the unit will attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as their assigned SSID value.

7" Modero Widescreen Touch Panels 59