AMX NXT-CV7, NXD-CV7 Pre-Wall Installation of the Conduit Box, CB-TP7 conduit box components

Installation

Pre-Wall Installation of the Conduit Box

Wall Mount panels (NXDs) are contained within an outer housing (back box). This back box is not removed when installing the NXD into a Conduit Box (CB-TP7). The back box is only removed to gain access for the replacement of the internal components.

INSTALLER: LEAVE A GAP BETWEEN THE STUD AND CONDUIT BOX MOUNTING TABS TO ACCOMMODATE THE DRYWALL or SHEETROCK.

This gap allows the installation of the drywall or sheetrock after the CB-TP7 Conduit Box has been installed.

The CB-TP7 is an optional metallic box that is secured onto a beam in a pre-wallsetting (where no walls are present). Installation procedures and configurations can vary depending on the installation environment. This section describes the installation procedures for the most common installation scenario. The most important thing to remember when mounting this conduit box is that the NXD-CV7 Mounting Tabs must lie flush against the outside of the sheetrock (FIG. 34).

Refer to SP-2258-02for detailed installation dimensions.

It is recommended that you cut out the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

The wiring knockouts on the left side will be used for the NXD-CV7 Wall Mount panel connectors, so always secure the conduit box to the stud using the Stud Mounting Holes on the right side of the box.

1.Rest the right Stud Mounting tabs onto the stud (keeping the knockouts on the left). Be sure to leave enough of a gap between the stud and NXD Mounting tabs to accommodate the installation of the drywall or sheetrock after the conduit box has been mounted. Ultimately, the Mounting Tabs should lie flush against the outside of the sheetrock.

2.Fasten the CB-TP7 conduit box to the stud through the holes on the right Stud Mounting tabs (FIG. 34), using either nails or screws.

Stud Mounting tabs

Stud

Wiring knockouts (must be located on left side)

NXD Mounting tabs (should lie flush against the outside of the wall)

Drywall or sheetrock

FIG. 34 CB-TP7 conduit box components

7" Modero Widescreen Touch Panels 33