AMX NXD-CV7, NXT-CV7 instruction manual Removing the default Button Trim Ring

Installation

Removing the Internal Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the Internal Faceplate.

4.Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it from the Faceplate (FIG. 30).

CV7 Panel/enclosure

Button latch

Trim

Ring

Latches

Light Pipe latch (black)

Button and Light Pipe removal

(showing the internal surface of Faceplate)

Default Button Trim Ring (with button openings)

Faceplate (outside surface shown)

FIG. 30 Removing the default Button Trim Ring

5.From along the internal surface of the Faceplate, remove the six buttons by gently bending each Button latch up and pulling the button outwards.

6.Remove the pair of clear light pipe strips by bending the two black light pipe latches inwards and pulling out the strip.

7.Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of the Faceplate (made available by the removal of the previous Trim Ring).

8.Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the internal Faceplate (FIG. 31).

9.Firmly press down around the No-Button Trim Ring until all of the latches are securely inserted into their openings on the Faceplate, and the No-Button Trim Ring is securely fastened. Verify the No-Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring and the outer surface of the Faceplate.

10.Place the Faceplate back onto the main NXD-CV7 unit. Make sure to align the Microphone, Light, and PIR Motion sensor locations on the main unit to their respective openings on the Faceplate assembly.

30 7" Modero Widescreen Touch Panels