HP CM6049f MFP manual Default IP, Dhcp Release, Dhcp Renew, Primary DNS, Secondary DNS, Address

Table 2-11Jetdirect menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
		Default IP	Specify the IP address to default to when the print
			server is unable to obtain an IP address from the
			network during a forced TCP/IP reconfiguration (for
			example, when manually configured to use BootP or
			DHCP).
			Auto IP: A link-local IP address 169.254.x.x is set.
			Legacy: The address 192.0.0.192 is set, consistent
			with older HP Jetdirect devices.
		DHCP Release	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The current DHCP lease is saved.
			Yes: The current DHCP lease and the leased IP
			address are released.
		DHCP Renew	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The print server does not request to renew
			the DHCP lease.
			Yes: The print server requests to renew the current
			DHCP lease.
		Primary DNS	Specify the IP address (n.n.n.n) of a Primary DNS
			Server.
		Secondary DNS	Specify the IP address (n.n.n.n) of a Secondary
			Domain Name System (DNS) Server.
	IPV6 Settings	Enable	Use this item to enable or disable IPv6 operation on the
			print server.
			Off: IPv6 is disabled.
			On (default): IPv6 is enabled.
		Address	Manual Settings: Use this item to manually set IPv6
			addresses on the print server.
			Enable: Select this item and choose On to enable
			manual configuration, or Off to disable manual
			configuration.
			Address: Use this item to type a 32 hexadecimal digit
			IPv6 node address that uses the colon hexadecimal
			syntax.
		DHCPV6 Policy	Router Specified: The stateful auto-configuration
			method to be used by the print server is determined by
			a router. The router specifies whether the print server
			obtains its address, its configuration information, or
			both from a DHCPv6 server.
			Router Unavailable: If a router is not available, the print
			server should attempt to obtain its stateful
			configuration from a DHCPv6 server.
			Always: Whether or not a router is available, the print
			server always attempts to obtain its stateful
			configuration from a DHCPv6 server.

30 Chapter 2 Control panel ENWW