HP CM6049f MFP Fax Send Settings Fax Dial Volume, High, Error Correction, Mode Disabled, Pulse

Table 2-12Fax Setup menu (continued)

Menu item Sub-menu item Sub-menu item Values Description

Fax Send Settings Fax Dial Volume Off

Low (default)

High

Use this feature to set the volume of the tones that you hear while the device dials the fax number.

Error Correction	Enabled (default)	When Error Correction Mode is enabled and
Mode	Disabled	an error occurs during fax transmission, the
		device sends or receives the error portion
		again.
JBIG Compression	Enabled (default)	JBIG compression reduces fax-transmission
	Disabled	time, which can result in lower phone
		charges. However, using JBIG compression
		sometimes causes compatibility problems
		with older fax machines. If this occurs, turn off
		JBIG compression.

Maximum Baud Rate	Select a value from
	the list. The default is
	33.6K.

Use this feature to set the maximum baud rate for receiving faxes. This can be used as a diagnostic tool for troubleshooting fax problems.

TCF T.30 Delay	Default (default)
Timer	Custom

This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide.

TCF Extend	Default (default)
	Custom

This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide.

Dialing Mode	Tone (default)	Select whether the device should use tone or
	Pulse	pulse dialing.
Redial On Busy	The range is between	Type the number of times the device should
	0 and 9. The factory	attempt to redial if the line is busy.
	default is 3 times.
Redial On No Answer	Never (default)	Use this feature to specify the number of
	Once	times the device should attempt to dial if the
		recipient fax number does not answer.
	Twice	NOTE: Twice is available in locations other
		than the United States and Canada.

ENWW Initial Setup menu 37