HP CM6049f MFP manual Replace the staple cartridge

6.Reconnect the power cable and remaining interface cables, and turn the product on.

7.Print a configuration page. In addition to a product configuration page and a Supplies Status page, an HP Jetdirect configuration page that contains network configuration and status information should also print.

If it does not print, turn the power to the device off and uninstall and reinstall the print server card to ensure that it is completely seated in the slot.

8.Perform one of these steps:

●Choose the correct port. See the computer or operating system documentation for instructions.

●Reinstall the software, choosing the network installation this time.

Replace the staple cartridge

If the optional HP 3-bin Stapler/Stacker Accessory or HP Booklet Maker/Finisher Accessory runs out of staples while it is stapling a print job, the product automatically stops, if set to stop when out. If the product is set to continue when out, the product will continue to print without stapling.

NOTE: Only replace the staple cartridge unit when the stapler/stacker or booklet maker has run out of staples. Removing the staple cartridge at other times can cause an error to occur.

NOTE: When the stapler/stacker or booklet maker runs out of staples, the stapler unit will return to its default position automatically.

Replace the staple cartridge

1.Open the front door of the booklet maker or stapler/stacker.

ENWW Replace supplies 201