HP CM6049f MFP Redial Interval, Detect Dial Tone Enabled, Dialing Prefix, Billing Codes, Numbers

Table 2-12Fax Setup menu (continued)

Menu item Sub-menu item Sub-menu item Values Description

Redial Interval	The range is between
	1 and 5 minutes. The
	factory default is 5
	minutes.

Use this feature to specify the number of minutes between dialing attempts if the recipient number is busy or not answering.

	Detect Dial Tone		Enabled	Use this feature to specify whether the device
			Disabled (default)	should check for a dial tone before sending a
				fax.
	Dialing Prefix		Off (default)	Use this feature to specify a prefix number
			Custom	that must be dialed when sending faxes from
				the device.
	Billing Codes		Off (default)	When billing codes are enabled, a prompt
			Custom	appears that asks the user to enter the billing
				code for an outgoing fax.
				The range is between 1 and 16 digits. The
				default is 1 digit.
Fax Receive Settings Rings To Answer			The range varies by	Use this feature to specify the number of rings
			location. The factory	that must occur before the fax modem
			default is 2 rings.	answers.
	Ring Interval		Default (default)	This setting is used to adjust for some PBX
			Custom	ring signals. Change this setting only when
				directed by an HP technical support agent.
	Ring Frequency		Default (default)	This setting should be left at the default value
			Custom	and only changed when directed by an HP
				technical support agent. Adjustment
				procedures associated with this setting are
				beyond the scope of this guide.
	Ringer Volume		Off	Set the volume for the fax ring-tone.
			Low (default)
			High
	Blocked Fax	Add Blocked	Type the fax number	Use this feature to add or delete numbers
	Numbers	Numbers	to add.	from the blocked fax list. The blocked fax list
				can contain up to 30 numbers. When the
		Remove Blocked	Select a fax number
				device receives a call from one of the blocked
		Numbers	to remove.	fax numbers, it deletes the incoming fax. It
				also logs the blocked fax in the activity log
		Clear All Blocked	No (default)
				along with job-accounting information.
		Numbers
			Yes

38 Chapter 2 Control panel ENWW