HP CM6049f MFP manual Link Speed, Print Protocols

Table 2-11Jetdirect menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
Link Speed			The link speed and communication mode of the print
			server must match the network. The available settings
			depend on the device and installed print server. Select
			one of the following link configuration settings:
			CAUTION: If you change the link setting, network
			communications with the print server and network
			device might be lost.
			Auto (default): The print server uses auto-negotiation
			to configure itself with the highest link speed and
			communication mode allowed. If auto-negotiation fails,
			either 100TX HALF or 10TX HALF is set depending on
			the detected link speed of the hub/switch port. (A
			1000T half-duplex selection is not supported.)
			10T Half: 10 Mbps, half-duplex operation.
			10T Full: 10 Mbps, Full-duplex operation.
			100TX Half: 100 Mbps, half-duplex operation.
			100TX Full: 100 Mbps, full-duplex operation.
			100TX Auto: Limits auto-negotiation to a maximum link
			speed of 100 Mbps.
			1000TX Full: 1000 Mbps, full-duplex operation.
Print Protocols			Use this item to print a page that lists the configuration
			of the following protocols: IPX/SPX, Novell NetWare,
			AppleTalk, DLC/LLC.

ENWW Initial Setup menu 35