SRA3 (Trays 3, 4, or 5 only)

B5 (ISO)

CAUTION: Do not print envelopes or unsupported sizes of paper from the 500-sheet trays. Print on these types of paper only from Tray 1. Do not overfill the input tray or open it while it is in use. Doing so can cause paper jams.

Load custom-size media into tray 2, 3, 4, or 5

To use custom media, change the size setting on the control panel to Custom and set the unit of measure, X dimension, and Y dimension. See Configure a tray to match print job settings

on page 111 for more information.

1.Slide open the tray from the product.

2.Load the print media as described in steps 2 through 4 of the “Load detectable (standard-size) media into Tray 2, 3, 4, or 5” section. Then proceed to step 3 in this procedure.

3.Slide the tray into the product. The control panel shows the tray type and size configuration. To specify specific custom dimensions, or if the type is not correct, touch Modify when the control panel prompts to change the size or type.

X

Y

4.Select Custom, and then select the Unit of measure, X dimension and Y dimension for the custom paper size.

5.Select the paper type and then touch Save.

6.If the configuration is correct, touch Save.

ENWW

Load paper and print media 105