Dacor PHW installation instructions Installation Instructions, Install the Electrical Connection

Installation Instructions

WARNING

•Do not install the range hood unless the electrical service provided meets the range hood specifications.

•Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.

•A qualified technician must complete the installation of this built-in appliance. The owner is responsible to make sure the hood is properly installed.

•To avoid an electric shock hazard and property damage, locate electric wires and water pipes and avoid drilling in the vicinity.

Install the Electrical Connection

4.Locate the chimney mounting bracket and position it against the ceiling as shown. Center it on the vertical center line drawn on the wall.

ANCHOR

CHIMNEY

MOUNTING

BRACKET

WARNING

•The electrical service to the range hood should be installed only by a licensed electrician.

The electrical connection box must be:

•Connected to a 120VAC, 60Hz dedicated, grounded, circuit protected by a 15 amp circuit breaker or time delay fuse.

•Located a minimum of 17 inches above the bottom of the range hood.

Install the Chimney Mounting Bracket

1.Determine the vertical center line for the range hood. The center line for the hood is usually the same as the center line of the range or cooktop.

2.Using a pencil, mark the vertical center line on the wall from where the bottom of hood will be located to where the top of the chimney will be located.

3.Draw a horizontal line 9 inches long at 90° to the vertical center line where the bottom of the hood will be located. The minimum allowable distance is 30” above the cooktop.

5.Mark the ceiling in two places through the holes in the top of the bracket. Remove the bracket from the ceiling.

6.Drill 5/16” holes through the two spots marked on the ceiling.

7.Insert the two of the provided wall anchors into the holes on the ceiling.

8.Place the chimney mounting bracket against the ceiling and attach it using two included 1 1/2” screws.

Install Blower Mounting Bracket

1.Find the mounting bracket template in the shipping box. Put the template against the wall and line up the horizontal line drawn on the wall with the horizontal line on the template.

2.Line up the vertical line drawn on the wall with the center line on the template. Iron out all creases and folds and tape the template to the wall using tape that will not damage the wall finish.

3.Using a sharp object, mark the wall through the template at the center of the three blower mounting bracket hole positions (near the top) and the position of the two “L” brackets, near the bottom.

4.Remove the template.