Dacor PHW Verify Proper Operation, Installation Checklist, If the hood fails to operate properly

Installation Instructions

Verify Proper Operation

1.Turn on power at the junction or fuse box.

2.If the control panel is not lit, turn on the main power switch located next to the light fixture on the underside of the hood.

3.Touch the light key. Verify that all the lights come on.

4.Touch the light key again to turn the lights off.

5.Touch the blower “+” key once and release. Verify that one light is showing on the blower speed indicator and that the blower is on at low speed.

6.Touch and release the blower “+” repeatedly, three times. Verify that with each touch of the key the number of lights on the blower speed indicator increases and that the blower speed increases.

7.Touch and hold the blower “-”key until the blower turns off.

If the hood fails to operate properly:

•Verify that power is supplied to the hood.

•Check the electrical connections to ensure that the installation has been completed correctly.

•Repeat the above test.

•If the appliance still does not work, contact the Dacor Customer Service Team at (800) 793-0093.

Do not attempt to repair the appliance yourself. Dacor is not responsible for service required to correct a faulty installation.

Installation Checklist

WARNING

•To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked.

•Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor range hood cannot be overemphasized.

□Is the blower assembly mounting bracket properly attached to the wall according to the instructions on page 6?

□Is the blower assembly tightly secured to the mounting bracket with the machine screws (see page 8)?

□Is the duct work completely installed? Are all joints attached with sheet metal screws and wrapped with duct tape (see pages 5 and 7)?

□Is the range hood wired and grounded according to these instructions and in accordance with all applicable electrical codes (see pages 5 and 9)?

□Is the tempered glass hood attached to the blower assembly as specified in this manual (see page 10)?

□Are the filters properly installed according to the use and care manual?

□Has proper operation been verified?

□Have any problems been noted on the warranty card or during the on-line activation? Has the warranty been activated on-line or the warranty card been filled out completely and mailed?

11