Daewoo 531X Alignment Procedure, Standard Adjustment Conditions, Pre-Adjustment, Main Adjustment

ALIGNMENT PROCEDURE

◆Standard Adjustment Conditions

1.Power source voltage : 100-240Vac 50/60Hz

2.Aging : Take at least 20 minutes warm-up time.

3.Signals

Video : Analog 0.7Vpp 75Ω terminal positive polarity

Synchronizing : TTL level Negative/Positive Separate

Deflection frequency

Horizontal Frequency : 30KHz - 54KHz

Vertical Frequency : 50Hz - 160Hz

◆Pre-Adjustment

1.B+ Adjustment

Adjust 50Vdc ± 0.1Vdc between D102 cathode and ground at 31.5KHz mode, varying VR001. Adjust 59Vdc ± 0.1Vdc between D510 cathode and ground at 31.5KHz mode, varying VR501.

◆Method to launch the factory mode

Step 1. Push the menu button.

Step 2. Push the menu button and plus control button ( ) for 5 times in same time.

◆Main Adjustment

1. Setting the Controls

Set the value of items as following.

Contrast : Max.(OSD value up to MAX)

Brightness : Center(Set the OSD value to center)

2.H.size, V.size, H.center, V.center, Pin Balance, Pincushion, Trapezoid Receive the cross hatch pattern of Factory preset mode.

H.size, V.size, H.center, V.center, Pin Balance, Pincushion, Trapezoid are adjusted at each mode. In Factory, Auto Alignment was done at each mode. Therefore, Factory preset mode has it’s own value according to each control.

3.Focus

(a)Set brightness control to center and contrast control to MAX.

(b)Receive all “H” character pattern of 1024 X 768 (48KHz, 60Hz)

(c)Adjust the Focus control of FBT to obtain best Focus.

4.Geometric Distortion Adjustment.

(a)Receive the cross hatch pattern of factory preset mode.

(b)Pincushion, Trapezoid, Pin Balance are adjusted the best geometric status.

5.White Balance Adjustment

(a)Select 9300°K on the OSD Menu.

(b)Receive a full white pattern of 54KHz mode signal by using the signal generator.

(c)Set the brightness control to the maximum, the contrast control to the maximum.

(d)Cut off the FBT screen VR.

(e)Receive all the black patterns. The luminance of the screen should be 0.5~1.0 Ft-L by using Screen VR.

(f)Select the R-BIAS, G-BIAS and B-BIAS on the control menu and adjust the +/– key to get the color coordinates in x=0.281 ± 0.015, y=0.311± 0.015.

(g)Receive a full white pattern. Adjust the brightness value to the center.

(h)Select the R-GAIN and B-GAIN and adjust the +/– key to get the color coordinates in x=0.281 ± 0.015, y=0.311 ± 0.015.

(i)Adjust the ABL control to get the screen luminance to 30 Ft/L (a full white pattern over 30 Ft/L)

(j)Check if the x, y coordinates of color analyzer is in x=0.281±0.015, y=0.311±0.015.

If the color coordinates is out of range, adjust the R. G. B BIAS & GAIN to get the coorinates in x=0.281, y=0.311. Make sure that the coordinates is in range.

(k)Select 6550°K on the OSD Menu and set the color coordinates in x=0.313, y=0.329 at the maximum contrast control and center brightness control

(l)Check if a full white pattern is over 30Ft/L.

13