6.GEOMETRY
6.1VERTICAL CENTER
1)Set the TV to “NORMAL I”mode.
2)Enter the service mode.
3)Locate the cusor at “V.CENTER”then press “VOL +” or “VOL
6.2VERTICAL SIZE
*The VERTICAL CENTER adjustment has to be done in advance.
1)Receive the Retma pattern.
2)Set the TV to “NORMAL I”mode.
3)Enter the service mode.
4)Locate the cursor at “V.SIZE”then press “VOL +”
or “VOL
6.3HORIZONTAL CENTER
1)Apply a RETMA PATTERN signal.
2)Set the TV to “NORMAL I”mode.
3)Enter the service mode.
4)Locate the cursor at “H.CENTER”then press “VOL +” or “VOL
if EEPROM(I702) has been changed;
-Option data has to be change and
-all alignment function has to be readjusted
* The initial state of adjustment are as follows;
-
* Service Remocon