• Step 4 - Placing Chassis
1.Insert narrow side of ‘Frame Guide Lower’ to rectangle holes located in bottom of chassis, and fasten it with Screw (Type D).
2.Insert Window Kit Frames to Top Guide and Lower Guide.
3.Fasten Shutter to side holes of Chassis with six Screws (Type D).
4.Place the chassis on the window sill and align it with Sill Bracket and sill with Lower Frame Guide and locate window sash to Top Frame Guide. (check the end of chassis for about 1/2 inches (12mm) distance below the level.)
5.Attach the Window seal B to Frame Guide Top.
6.Fasten Front Chassis Bracket to sill with three Screws (Type C).
7.Fasten Sash Bracket with Screw (Type C) to top of indoor window sash or directly into side of window sash or directly into side of window frame. This will prevent raising of the window from the outside. If you have a hard wood or metal window frame, a 1/8 inch pilot hole may be needed in order to drive the screws.
8.Attach the Window Seal A to window (see the picture shown in step 8, page 8)
FRAME 
Screw (Type D, both side) Guide Lower
Frame Guide Top
Window Seal B
Screw
(Type C)
SASH BRACKET
Screw (Type C)
• Step 5 - Secure Window Shutter
CAUTION Do not drill into window sash until window has been inspected to make sure drilling or screw will not damage any locking or lifting mechanism located in the frame.
To provide a proper seal, pull each expandable side Window Shutter out and up until it is tight against the window frame. Using the hole in the top and bottom of each Window Kit Frame as a guide, secure Window Kit Frame in window sash and on the window sill.
WINDOW
KIT FRAME
| Screw (Type C) | |
WINDOW | WINDOW | |
SASH | ||
SHUTTER | ||
|
WINDOW
FRAME
Screw
(Type C)
INNER WINDOW SILL
7
