INSTALLATION INSTRUCTIONS
• WINDOW REQUIREMENTS
These instructions are provided for a standard double hung window or mobile home double hung window installation in windows 24 inch (610mm) to 36 in (914mm). The upper and lower sash must open sufficiently to allow a clear vertical opening of 15 in (381mm) from
the bottom of the sash to the window sill. Select a centrally located window on the side of the room that
receives the least direct sunlight. There should be no obstruction to air flow either inside(i.e curtains) or outside (i.e fence, wall or
bushes). Read this entire installation manual thoroughly before beginning the
installation.
Make sure you have the necessary tools and other materials for the
job. Study the illustrations in these instructions to become familiar with important details of the installation process.
Read the Use & Care manual to become familiar with the operation of your room air conditioner.
IMPORTANT :
It is important, both for your personal safety and to avoid possible damage to your home, that you observe the safety instructions that are given.
After installing the unit,
For best results, perform the installation procedure in the order given. Doing so will minimize the time required to install the unit.
• BASIC TOOLS NEEDED
• Standard screwdriver | • Phillips screwdriver | • Sharp knife |
• Carpenter’s level | • 1/4” hex driver | • Tape measure |
• Electric drill | • 1/8” drill bit |
|
• SAFETY INSTRUCTIONS |
|
|
CAUTION
• The air conditioner shall be installed in accordance with the national wiring regulation.
1.Install an exclusive main power switch (main circuit breaker) or GFI (Ground Fault Interrupted) switch.
2.Be sure to use grounded power source.
3.Power source for
4.Consumer must pay charges for wiring and installation.
3