WASHER SAFETY
Save these instructions
Your safety is important to us.
To reduce the risk of fire, electrical shock, or injury when using your washer adhere to the following basic precautions.
Read all instructions before using your washer
•Flammable fluids
Do not add flammable fluids to your wash water.These substances give off vapors that can create a fire hazard or explosion.
•After starting a cycle, do not reach into the washer until all motions stop.
•Do not tamper with the controls.
•The appliance is not intended for use by young children or infirm persons without supervision.
•If the supply cord is damaged, it must be replaced by the manufacturer, or its service agent or a similarly qualified person in order to avoid a hazard.
•If the appliance is supplied from a cord extension set or electrical portable outlet device it should be positioned so that it is not subjected to splashing or ingress of moisture.
Please ...
•Have only a qualified person install, repair, or replace parts on washer.
•Maintain washer properly.
•Protect washer from the weather and keep it where the temperature will not fall below freezing.
•Do not install the washer at a place of extremely high humidity. It could cause an electric shock or a short circuit.
•Connect washer to the correct outlet, electrical supply, water supply, and drain supply.
•Door will not open in case of high temperature inside tub.
•Prevent children from entering machine.
Understanding your responsibilities
•Do not use chlorine bleach and ammonia or acid(such as vinegar or rust remover) in the same wash. Hazardous fumes can form.
•Unplug power supply cord before attempting to service your washer.
•Do not wash fiberglass material.
Small particles can stick to fabrics washed in following loads and cause skin irritation.
•Do not spray water on the control panel of the washer. It could cause fire or an electric shock.
•In case of the dual valve model, if you connect only cold water inlet valve, while water temperature is selected as hot or warm, there can be water leakage from unconnected water inlet valve.
•This appliance must be grounded.
To avoide electrical shock, use a metal pipe for the ground connection.
3