Daewoo DWC-ED1232 instruction manual Inlet Hose Connection, For Ordinary Tap

INLET HOSE CONNECTION

The washer should be connected to the water mains using new hose sets and old hose sets should not be reused.

In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.

Option : Be careful not to confuse hot water inlet and cold water inlet.

For Ordinary Tap

1Pull down the collar of the	2Loosen the four screws	3Fit the water tap adapter
inlet hose to separate it	properly in order to fit into	into the water tap and
from the water tap	water tap.	tighten the four screws
adapter.		evenly while pushing up
		the adapter so that the
		rubber packing can stick
		to the water tap tightly.

		TAPE
4Remove the tape, and	5Connect the inlet hose to	6Connect the inlet hose
screw connector B into	the water tap adapter by	adapter of the hose to the
connect A tightly.	pulling down the collar of	water inlet of the washer
	the hose end.	by turning it clockwise to
		be fixed tightly.

Connector A

Connector B

• Please check the rubber packing present inside the inlet hose adapter of the hose.

For Screw-Shaped Tap

1Connect the inlet hose to the water tap by screwing the connector tightly.

Rubber

ConnectorPacking

Hose Connector

2Connect the connector- inlet supplied if necessary.

Connector inlet

Rubber

ConnectorPacking

Hose Connector

3Connect the inlet hose adapter to the water inlet

of a washer and turn it to be fixed.

*Check the packing in the inlet

5