Inlet hose connection
The washer should be connected to the water mains using new hose sets and old hose sets should not be reused.
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
1 Pull down the collar of the inlet | 2 Loosen the four screws properly | 3 Fit the water tap adapter into |
hose to separate it from the | in order to fit into water tap. | the water tap and tighten the |
water tap adapter. |
| four screws evenly while |
|
| pushing up the adapter so that |
|
| the rubber packing can stick to |
|
| the water tap tightly. |
|
| TAPE |
4 Remove the tape, and screw | 5 Connect the inlet hose to the | 6 Connect the inlet hose adapter |
connector B into connect A | water tap adapter by pulling | of the hose to the water inlet of |
tightly. | down the collar of the hose end. | the washer by turning it |
|
| clockwise to be fixed tightly. |
Raccorclement A | • Please check the rubber packing |
Raccorclement B | |
| present inside the inlet hose |
| adapter of the hose. |
For Screw-Shaped Tap
1Connect the inlet hose to the water tap by screwing the connector tightly.
Rubber
Connector
Packing
Hose Connector
2Connect the connector- inlet supplied if necessary.
Connector
inlet
Rubber
Connector
Packing
Hose Connector
3Connect the inlet hose adapter to the water inlet of a washer and turn it to be fixed.
*Check the packing in the inlet
