InstallationEl instructions, Location of washer

InstallationEl instructions

1.Before operating the washer, remove the transit bolts(4ea) along with the rubber.

•If the bolts are not removed, it may cause heavy vibration, noise and malfunction.

3. Close the holes with the cap holders supplied.

2.Unscrew the 4 bolts with the 10mm hex wrench or spanner or cross-tip screwdriver. Keep the 4 bolts for a later time.

•When the appliance is transported, transit bolts will be re-used.

•Check location where the washer will be installed. Make sure you have everything necessary for correct installation.

•Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.

	• Do not place or store laundry products on top of washer at any times	Drain Hose
	• Install the washer on the horizontal solid floor.	Drain Hose
	• Install the washer on the horizontal solid floor.	Washer
	If the washer is installed on an unsuitable floor, it could make	Washer

	considerable noise, vibrate severely and cause a malfunction. If the
	washer is not level, adjust leg up or down for horizontal installation.
	• Ventilation openings must not be obstructed by carpeting when the
	washer is installed on a carpeted floor.	Laundry
	• Leave some space (right & left : 2cm, rear : 10cm).	Tub
	• In case of built-in installation, the distance between top of the washer and	approx.
	bottom of upper plate should be at least 3mm.	2cm

E-5