Installing and Removing the Server Board
Installing the Server Board
1.Observe the safety and ESD precautions at the beginning of this book. See “Safety Information”.
2.Power down the server and unplug all peripheral devices and the AC power cable(s).
3.Remove the server system cover. For instructions, see “Removing the System Cover”.
4.Remove the processor air duct. For instructions, see “Removing the Processor Air Duct”.
5.Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser Assembly”.
6.Remove the optical drive cable if installed.
7.Remove the bridge board. For instructions, see Figure 61 “Removing the Bridge Board from the Server System” on page
8.Remove the large air baffle. For instructions, see “Removing the Large Air Baffle”.
9.Remove the fan module assembly. For instructions, see “Replacing a Fan Module”.
10.Place the server board into the server system as shown in the figure below (see letter “A”), and attach the server board with six screws (see letter “B”).
B
A
AF000025
Figure 71. Installing the Server Board
Intel® Server System SR2500AL User’s Guide | 81 |
