Intel SR2500AL manual

8.If you have a passive mid-plane installed in your system, install the power cable to the backplane and the sixth HDD board (see letter “A”). Install one end of the long SATA cable (labeled HSBP/TAPE) to the sixth HDD board (see letter “B”) and route the cable through the air baffle as shown (see letter “C”). Connect the other end of the cable (labeled SERVER BOARD) to the SATA5 connector on the server board (see letter “D” in the figure below). Continue with step 9.

C

D

A

B

AF002122

Figure 49. Installing Power and SATA Cables (Passive Mid-Plane Installed)

Note: You will not use the short SATA cable from the 6th HDD kit in a system with a passive mid- plane.

9.Install a hard drive into the sixth hard drive bay. For instructions, see “Installing a SAS or SATA Hot-swap Hard Disk Drive”.

10.Install the server system cover. For instructions, see “Installing the Server System Cover”.

11.(Optional) Install the front bezel. For instructions, see “Installing the Front Bezel”.

12.Plug all peripheral devices and the AC power cable(s) into the server.

56 Intel® Server System SR2500AL User’s Guide