Methode of exchanging main parts
4)Cut the both ends of glass tube heater tube heater lead wires and insulate and seal lead tip remaining in refrigerator with tape etc.
Heater
Cover
5)Pull out the glass tube heater from the heater supporter with heater covers remaining. (upper and lower) (Do not apply much power on the heater supporter.)
Heater Cover (Bottom)
Raise
d
Heater
Glass tube fi t heater Lead wire
Heater Cover (Top)
6)Install the heater covers (upper and lower) on a new glass tube heater. (Make the cover with holes the lower one)
|
|
| Heater |
|
|
| Cover |
| Place the glass tube heater lead wire shownFrontsid | AL | Lead |
7) |
| ||
|
| ||
| as below and fasten the shaded area with |
|
|
| type. |
|
|
8) | Fin insert the lead wire connection terminals. |
|
|
| (Same colored lead wires) |
|
|
9) | Set the evaporator on normal position and |
| Glass tube |
| secure the fastening screws. |
| |
|
| h t | |
|
|
|
