Daewoo KOR-631G manual Operation Procedure, Controls, Setting the Clock, Time Defrosting

The display will show “ : 0” when the oven is plugged in.

OPERATION PROCEDURE

This section includes useful information about oven operation.

1.Plug power supply cord into a 230V 50Hz power outlet.

2.After placing the food in a suitable container, open the oven door and put it on the glass tray. The glass tray and roller guide must always be in place during cooking.

3.Shut the door. Make sure that it is firmly closed.

CONTROLS

SETTING THE CLOCK

When the oven is first plugged in, the display will flash “ :0” and a tone will sound. If the AC power ever goes off, the display shows “ :0” when the power comes back on.

1

2

The oven light is on only when the microwave oven is operating.

The oven door can be opened at any time during operation by touching the door release button on the control panel. The oven will automatically shut off.

7 When the STOP/CLEAR pad is touched during the oven operation, the oven stops cooking and all information retained. To erase all information(except the present time), touch the STOP/CLEAR pad once more. If the oven door is opened during the oven operation, all information is retained.

Clock

1.Touch Clock pad.

This is a 12 hour clock system.

2.Touch Clock pad once more. This is a 24 hour clock system.

NOTE : This oven has multiple clock systems. If you want 12 hour clock system, omit this step.

3 Each time a pad is touched, a BEEP will sound to acknowledge the touch.

4 The oven automatically cooks on full power unless set to a lower power level.

5

8

If the START pad is touched and the oven does not operate, check the area between the door and door seal for obstructions and make sure the door is closed securely. The oven will not start cooking until the door is completely closed or the program has been reset.

3.Enter the correct time of day by touching the time set pads.

4.Touch Clock pad.

Clock

The display stops blinking, and the colon starts blinking. If you selected 12 hour clock system, this digital clock allows you to set from 1:00 to 12:59. If you selected 24 hour clock system, this digital clock allows you to set from 0:00 to 23:59.

6 Time clock returns to the present time when the cooking time ends.

Make sure the oven is properly installed and plugged into the electrical outlet.

NOTE: If you attempt to enter an incorrect time, the time will not be set and a error signal tone will sound. Touch the Clock pad and re-enter the time.

WATTAGE OUTPUT CHART

•The power-level is set by pressing the Power pad. The chart shows the display, the power level and the percentage of power.

TIME DEFROSTING

When Defrost is selected, the automatic cycle divides the defrosting time into periods of alternating defrost and stand times by cycling on and off.

Touch Power pad	Power level (Display)	Approximate Percentage of Power
once	P-HI	100%
twice	P-90	90%
3 times	P-80	80%
4 times	P-70	70%
5 times	P-60	60%
6 times	P-50	50%

1. Touch Defrost pad.

Defrost

2. Touch the time set pads for the desired time.

The DEF indicator lights and " : 0" is displayed.

The display will show what you touched.

NOTE: Your oven can be programmed for 59 minutes 90 seconds.(59:90)

7 times	P-40	40%
8 times	P-30	30%
9 times	P-20	20%
10 times	P-10	10%
11 times	P-00	0%

3. Touch START pad.

When you touch START pad, the DEF indicator starts blinking to show the oven is in the DEFROST mode. The display counts down the time to show you how much defrosting time is left in the DEFROST mode. The oven beeps during the defrosting cycle to signal that the food needs to be turned or rearranged. When the defrosting time ends, you will hear 3 beeps.

7 8