Dakota Alert WHT-3000 owner manual Table to select tones, Coding the receiver

Table to select tones:

Switch	Switch	Channel	12-volt	Tune
9	10		DC output
On	On	1	Yes	Classical
Off	On	2	No	Westminster
On	Off	3	No	Ding Dong
Off	Off	4	No	Whistle

Coding the receiver:

1.Open the receiver case by inserting a small screwdriver into one of the pry notches on the side of the case. (refer to receiver manual)

2.Gently lift off the front cover.

3.Locate the eight dip switches on the receiver and make sure they are set identically to dip switches 1-8 on the transmitter.

Note: If more than one transmitter is used with the receiver, the first eight dip switch- es of all transmitters must match the eight dip switches of the receiver.

Note: Whenever a change is made to the time jumper or the dip switches, the re- ceiver must be turned OFF and then back ON to operate properly.

Frequency: 433.92 MHz

Operating range: -30˚F to 120˚F

Battery life: 6-12 months

Reset time: 15 seconds

5.