Danby DAC8011E Using the Remote Controller, Swing Operation, Sleep Operation, Timer Operation

Operating Instructions

USING THE REMOTE

CONTROLLER

SWING OPERATION

Use the SWING button to adjust the Left/Right airflow direction.

BUTTONS

ON/OFF MODE

1	1) Press this button while the unit is
	operational, the vertical louvers

TEMP	TEMP
UP	DOWN
	SWING
FAN	TIMER
	SLEEP

ON/OFF		MODE
TEMP	S	TEMP
UP		DOWN
	ENERGY
	SAVER
FAN		TIMER
CLEAN		SLEEP
AIR

ON/OFF		MODE
TEMP	S	TEMP
UP		DOWN
	ENERGY
	SAVER
FAN		TIMER
CLEAN		SLEEP
AIR

automatically swing right and left

sweeping the cold/hot air alternately to

obtain comfortable cooling/heating.

2) Press the SWING button again to stop

the swing operation.

SLEEP OPERATION

•In this mode, the selected temperature will increase(in cooling mode) / decrease (in heating mode) by 2°F 30 minutes after the mode is selected.

•The temperature will then increase by another 2°F after an additional 30 minutes.

•This new temperature will be maintained for 7 hours before it returns to the

1 originally selected temperature. This ends the Sleep mode and the unit will continue to operate as originally programmed.

•The Sleep mode program can be cancelled at any time during operation by again pressing the Sleep button.

TIMER OPERATION

press the TIMER button can set the Auto- start and Auto-stop time of the unit.

NOTE:

•To set Auto-start time, the unit must be in the OFF position.

•To set Auto-stop time, the unit must be in the ON postion.

To set the Auto-start time.

1.Push the TIMER button when the unit is

1 off, only the Auto-start feature can be set.

2.Keep pressing the TIMER button, each press will increase the selected time by 1 hour increments, up to 12 hours.

3.The time can be set in a range of 0~12 hours.

4.After the desired time has established, wait for about 10 seconds until the setting temperature reverts back in the display window of the air conditioner. This indicates the program is set.

12