Installation Instructions - Intergrated Application

Tools You Will

Need

 

Safety Glasses

Gloves

 

Level

 

 

 

FOR YOUR SAFETY:

 

 

 

 

 

 

While performing

 

 

Flashlight

installations described in

 

 

 

 

 

 

this section, gloves, safety

 

 

 

Carpenters

glasses or goggles should

 

 

 

 

 

Measuring

Square

be worn.

Drill & Hole Saw Set

Tape

 

 

 

Preparing the Enclosure

Electrical Requirements:

The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

•It is recommended that you do not install the beverage center into a corner (i.e. directly beside a wall). This is to allow the door(s) to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to dam- aging the door gasket(s).

•The rough cabinet opening must be on a level floor area and at least 25” deep by 24” wide. The opening should also have a height of at least 35”.

 

 

Fig D

 

1-1/2” dia. hole

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

*if electical

1

 

 

 

 

 

 

 

 

 

 

 

 

outlet

 

 

 

 

 

 

 

 

 

 

 

 

1 /2” diam. hole

 

 

 

 

 

 

 

 

 

is in adjacent* If electrical out-

 

 

 

 

 

 

 

 

 

cabinetry let is in adjacent25”

 

35” From

 

 

 

 

 

 

 

 

24”

 

 

 

 

 

 

 

cabinetry.

 

Underside of

 

 

 

 

 

 

 

2”Min.

 

Countertop to

 

 

 

 

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

34 /4”

from

 

 

 

Floor

 

 

 

 

Electrical Access

 

 

 

underside

 

 

 

 

 

 

 

 

of

 

 

 

 

 

 

 

 

 

 

countertop

 

 

 

 

 

 

to floor

 

 

 

 

 

6”

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

24”

•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig D.).

•If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” diameter hole to admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.

Cabinets

Square

and

Plumb Cabinets square

and

plumb

FigD

8