Danby DBC2760BLS Installation Instructions - Intergrated Application, Tools You Will Need, Fig C

Installation Instructions - Intergrated Application

Tools You Will Need

FOR YOUR SAFETY:

While performing installations described in this section, gloves, safety glasses or goggles should be worn.

Safety Glasses			Level
	Gloves
		Flashlight
			Carpenters
Drill & Hole Saw set		Measuring	Square
		Tape

Preparing the Enclosure

Electrical Requirements:

The appliance must be connected to an individual properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

•It is recommended that you do not install the Beverage Center into a corner (i.e. directly beside a wall). This is to allow the door(s) to have a greater then 90° open- ing swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gas- ket(s).

•The rough cabinet opening must be on a level floor area and at least 24” deep* by 24” wide. The opening should also have a height of at least 34-1/2”.

•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig C.).

Important: If the electrical out- let is surface mounted (not flush) within the enclosure, the depth requirment for the installation be affected.

•If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” diameter hole to admit the power cord.

Fig C

	1-1/2” dia. hole
	*if electical outlet
	is in adjacent
34-1/2” From	cabinetry		24”
		2”Min*
Underside of
Countertop to
Floor	Electrical Access

6”

24”

Cabinets

Square

and

Plumb

*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja- cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.

8