Danby DFF311WDD Important Safety Information, Installation Instructions, Grounding Instructions

Models: DFF311WDD

1 21
Download 21 pages 6.94 Kb
Page 3
Image 3
IMPORTANT SAFETY INFORMATION

IMPORTANT SAFETY INFORMATION

READ ALL SAFETY INFORMATION BEFORE USING

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electrical current. This appli- ance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

READ ALL SAFETY INFORMATION BEFORE USINGWARNING

Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

DO NOT USE AN EXTENSION CORD

Use an exclusive wall outlet. Do not connect your refrigerator to extension cords or together with any other appliance in the same wall outlet.

IMPORTANT WARNING

An empty refrigerator can pose a threat to children. To render the unit harmless we strongly recommend removing the door prior to disposal. Before you throw away your old refrigerator or freezer:

Take off the doors.

Leave the shelves in place so that children may not easily climb inside.

SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

LOCATION

Remove exterior and interior packaging, wipe the

outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely around the unit. Keep the rear of the refrigera- tor 5 inches away from the wall.

LOCATION

1)Select a place with a strong, level floor.

2)Allow 5 inches of space between a wall and the back of the refrigerator, and 1 to 2 inches of space between a wall and a refrigerator side.

3)Avoid direct sunlight and heat. Direct sunlight

may affect the acrylic coating on the refrigerator exterior. Heat sources nearby will cause higher electricity consump- tion.

The refrigeration system in this refrigerator is a “Frost Free” system. This type of system requires no user intervention (i.e. defrosting) other than selecting required cooling temperatures and the usual care and

maintenance.

To avoid vibration, the unit must be leveled. This is accom- plished by adjusting the 2 front leveling legs located under the refrigerator. (see Figure on the right)

NOTES:

This appliance is intended for FREE-STANDING INSTALLATION ONLY, and is NOT intended to be built-in.

This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation. Do not place the refrigerator in your garage or other places that are not within the operating temperature range.

IMPORTANT: Install this appliance in an area where the ambi- ent temperature is between 55°F (13°C) and 90°F (32°C). If the temperature around the

appliance is too low or high, cooling ability will be affected.

Bottom of Unit

GROUNDING INSTRUCTIONSDO NOT USE AN EXTENSION CORDUse pliers or wrench to adjustIMPORTANT WARNINGSAVE THESE INSTRUCTIONS!theINSTALLATION INSTRUCTIONS leveling legsLeveling Legs

Turn counter- clockwise to

raise the unit.

Turn clockwise to LOCATIONBottom of Unit lower the unit Use pliers or wrench to adjustthe leveling legsLeveling Legsraise the unit.Manual backgroundManual background

1

Page 3
Image 3
Danby DFF311WDD Important Safety Information, Installation Instructions, Grounding Instructions, Location, Bottom of Unit