Danby DFF311WDD Door Reversal Instructions, Fig. A Fig. B, Fig. C, This Procedure Is Now Complete

INSTALLATION INSTRUCTIONS

DOOR REVERSAL

INSTRUCTIONS

CAUTION

To avoid personal injury to yourself and/or property, we recommend someone assist you during the door reversal process.

1)To access the lower hinge assembly, tilt back the refrigerator cabinet. (Fig. A)

2)Remove both leveling legs located at the front of the cabinet.

3)Remove the screws holding the lower hinge assembly to the cabinet. (Fig. A)

4)Remove the main door assembly from the refrigerator cabinet (open door and pull down).

5)Remove the screws from the middle hinge assembly, then remove the hinge and freezer door.

6)Remove (unscrew) the top hinge pin. (Fig. B)

7)Re-install the main door top hinge pin on the opposite side of the cabinet. (Fig. B)

8)Remove the door plug and door bushing located on the top and bottom of each cabinet. (Fig. B)

9)Interchange positiones (i.e., door plug right side, door bushing left side).

10)Re-install freezer door assembly on cabinet.

11)Re-install the middle hinge assembly on the opposite side. (Fig.C)

12)Make sure the door assembly is properly aligned on the cabinet before tightening the hinge screws.

13)Re-install the main door assembly on the cabinet.

14)Re-install the lower hinge assembly on the opposite side, making sure to change the bushing and screw on the opposite sides on the bottom of unit.

15)Make sure the door assembly is properly aligned on the cabinet before tightening lower hinge screws.

16)Re-install both leveling legs.

THIS PROCEDURE IS NOW COMPLETE.

If you find the direction of opening the door on your appliance inconvenient, you can change it by following the steps shown in the below diagrams.

Fig. A

Fig. B

Center Hinge

Fig. C

2