CHILL'N TAPASSEMBLY INSTRUCTIONS:
1.Remove Worktop: Using a Phillips Screwdriver, remove the three screws located on the front underside edge of the worktop and the three screws located at the rear (back) side of the worktop.
See Fig's. 1 & 2
Remove the worktop from the cabinet and position the
worktop on top of the cabinet so that the front cornersFig. 1 are staggered across the front corners of the cabinet.
2.Installation of Top Rail: Attach the chrome rail to the work top using four
3. | Fig. 2 | |
cabinet, then lower the rear side of the worktop over the | ||
| ||
backside of the cabinet. Secure using the same screws |
| |
removed earlier. (the smaller screws at the front the larger |
| |
screws at the rear) |
| |
4. Installation of CO2 Cylinder Support: Install the cylinder |
| |
support onto the four studs located on the exterior back |
| |
wall of the cabinet. (no tools required) Align the holes in |
| |
the cylinder support with the studs and push down firmly. | Fig. 3 | |
See Fig. 3 |
5.Installation of CO2 Cylinder: Install your " fully charged" CO2 cylinder into the support stand. IMPORTANT NOTICE:
ALWAYS EXERCISE EXTREME CAUTION WHEN HANDLING PRESSURIZED C02 CYLINDERS:
6.Installation of C02 Regulator: Attach the CO2 Regulator to
the C02 cylinder by screwing the regulator nut onto cylinder | Fig. 4 | |
valve and tighten (snug) using an adjustable wrench. | ||
|
7.Installation of C02 Air Line Hose to Regulator: Attach one end of the (red) air line hose to the hose barb connection on the CO2 regulator. Secure hose by using one of the two (self locking) black plastic snap on clamps provided.
(use pliers to snap the clamp tight to assure that there are no leaks)
See Fig. 5
Fig. 5
5