Danby DPAC 13009 operating instructions Troubleshooting, Problem, Possible Cause, Solution

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE
• Unit does not work	• Power is out

•The plug is not plugged in properly

•The full-tank indicator is ON; tank is full

•Current leaking or pressing test button on LCDI plug

• Unit suddenly stops	• Indoor set temperature has been
during operation	reached
	• The preset time is up
	• The full-tank indicator is ON; tank is
	full
• Unit runs intermittently	• Malfunction
	• Surrounding temperature is too
	high/low
	• Exhaust duct hose is blocked
• Unit functions but the room	• Window or door is open in room
is not cooled	• There is a heat source or too many
	people in the room
	• Air intake grill is clogged
	• Filter is too dirty
	• Temperature setting is too high
• Condensed water spills out	• The tank is nearly full
when moving the unit

SOLUTION

•Wait for power to return

•Plug in properly

•Remove drain water from the drain tank

•Press the reset button after resolving problem

•Reset the temperature level

•Reset the timer

•Remove drain water from the drain tank

•Contact your dealer

•This is normal

•Check the duct hose

•Close all windows/doors

•Move any heat sources from room

•Clean air intake grill

•Replace the filter

•Lower temp. setting

•Remove drain plug on rear bottom and drain out water

12