INSTALLATION INSTRUCTIONS

TOOLS YOU WILL NEED

 

PREPARING THE ENCLOSURE

 

 

 

FOR YOUR SAFETY

 

TOOLS YOU WILL NEED

 

 

 

•While performing installations described in this section, gloves and goggles or safety glasses should be worn.

•Remove interior and exterior packaging prior to installation.

•Before connecting the appliance to a power source, let it stand upright for approximately 2 hours; this will reduce the possibilty of a malfunction in the cooling system from handling during transportation.

•Place your Party Center on a floor that is strong enough to support it when it is fully loaded. To level your Party Center, adjust the front leveling leg at the bottom of the Party Center.

•Locate the Party Center away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit to perform improperly.

•Avoid locating the unit in moist areas.

•Plug the Party Center into an exclusive, properly installed- grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord.

Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center.

•Do not cover shelves with aluminum foil or any other material which may prevent air circulation.

LOCATION

The Party Center should be placed where the ambient temperature is between 4-32°C (39-90°F). If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The internal temperature range of 4-18°C (39-64°F) may not be reached.

While performing installations described in this section, gloves, safety glasses or goggles should be worn.

ELECTRICAL REQUIREMENTS: The appliance must be connected to an individual, properly grounded electrical out- let, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

•It is recommended that you do not install the Party Center into a corner (i.e. directly beside a wall). This is to allow the door to have a greater then 90° opening swing. A limited door swing may lead to damaging the door gasket.

•The rough cabinet opening must be on a level floor area and at least 26” deep by 24” wide. The opening should also have a height of at least 34 2/4”.

•The electrical oulet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig A).

•If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” diameter hole to admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.

Fig A

 

11/2” diam. hole

 

 

 

 

 

* If electrical out-

 

 

 

 

 

let is in adjacent

 

 

 

 

 

cabinetry.

 

 

 

 

 

 

 

26”

 

342/4” from

 

 

 

 

 

 

 

 

 

 

underside

 

 

 

 

 

of

 

 

 

 

Cabinets

countertop

 

 

 

 

to floor

 

 

 

 

square

 

 

 

 

 

and

 

 

 

 

 

plumb

 

 

 

 

 

 

 

 

2