OPERATING INSTRUCTIONS

SETTING THE

 

SHELF INSTRUCTIONS

TEMPERATURE

 

 

 

Each cooling compartment of your Party Center (left & right) is independently controlled. To set the temperature;

1)Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of:

12°C (54°F) – Wine storage zone (left upper zone) -7°C (14°F) –Icemaker zone (left lower zone)

7°C (45°F) –Beverage zone (right zone)

Temperature set range:

4-18°C (39-64 °F) – Wine storage zone (left upper zone) -7°C/-13°C (9°F/19°F) – Icemaker zone (left lower zone) 4-18°C (39-64 °F) – Beverage zone (right zone)

2)When you set the temperature for wine storage zone (left upper zone) and beverage zone (right zone), push “UP/DOWN” button to adjust setting temperature. Push “UP” or “DOWN” button one time, and the temperature will increase or reduce by one degree. When you push the “UP/DOWN” buttons to set the temperature, the digital LED will flash and display setting temperature, and after 5 seconds it will go back to display the actual ambient temperature.

3)When you start/shut off ice maker function, push the “ON/OFF” button; the ice maker will commence operation upon pushing the “ON” button, and the temperature inside the ice maker zone will be -13°C (9°F); when the light adjacent to the ON/OFF buttons is illuminated, this indicates the ice maker is operational. To turn the ice maker off, press the ON/OFF button again and the light adjacent to the ON/OFF button will cease to illuminate- Upon shutting off the ice maker, the LED display will flash and display the set temperature, and after 5 seconds of flashing, will go back to displaying the actual temperature. When the ice maker is not in operation, the temperature will be -7°C (19°F).

4)To view the "set" temperature at any time, press and hold the corresponding button for approximately 5 seconds; the "set" temperature will temporarily "flash" in the LED display for 5 seconds:

Flashing LED = Set TemperatureSteady LED= Cabinet Temperature

•To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment.

•For easy access to the storage content, you must pull the shelves approximately 1/3 of the way out of the rail compartment;

•To fit or remove the shelf, tilt the shelf as per Fig.B, and simply pull out, or push in the shelf until it sits on the support brackets securely.

Fig. B

ICE MAKER INSTRUCTIONS

•Pull out the ice maker box in order to remove ice easily.NOTE:

•If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Party Center will not start.

•When you use the Party Center for the first time or restart the Party Center after having been shut off for a long time,there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the Party Center is running for a few hours everything will return to normal.

4