INSTALLATION INSTRUCTIONS
TOOLS YOU
WILL NEED
WARNING: While performing the installations described in this section; gloves and safety glasses or goggles should be worn.
Safety Glasses | Gloves | Level |
Flashlight
|
| Carpenter’s |
Drill & Hole Saw set | Measuring | Square |
Tape |
|
PREPARING THE | Electrical Requirements: The appliance must be connected to an individual, |
ENCLOSURE | properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker |
| or time delay fuse. |
|
•It is recommended that you do not install the wine and beverage center into a corner (i.e. directly beside a wall). This is to allow the door to have a greater than 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket.
•The rough cabinet opening must be on a level floor area and at least 267/8” (68.26cm) deep* by 233/4” (60.33cm) wide. The opening should also have a height of at least 70 1/16” (178cm).
•The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig. B).
Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement for the installation may be affected.
•If the electrical outlet is located inside the adjacent cabinetry, cut a 11/2” (3.81cm) diameter hole to admit the power cord.
IMPORTANT: | IMPORTANT: Do not include the door within the enclosure; leave it outside of the |
DOOR SWING | enclosure to prevent the door swing from being obstructed. |
|
|
Fig. B: The listed depth requirement for the installation is assuming that the electrical outlet is located in the adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
Fig. B
701/16”/
178cm
267/8”*/
68.26cm
Electrical
Access: 2” /
3.81cm
Cabinets must be square and plumb.
233/4”/ 60.33cm
3
