Operation
ON button located on the remote control transmitter.
!NOTE: You will have only 10 seconds to perform this last step. Failure to do so will result in these steps needing to be followed again.
This will synchronize the remote control transmitter and receiver.
Figure 6
OFF
Button
ON
Button
Battery
Cover
Maintenance
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for the light bulbs to cool before touching them to avoid accidental burning of the skin. The light bulbs need to be replaced when you notice a dark section of
the flame or when the clarity and detail of the log ember bed exterior reduces. There are three (3) bulbs under the Log Set Assembly, which generate the
flames and embers, and two (2) bulbs above that illuminate the log exterior.
Lower Light Bulb Requirements
Quantity of three (3) clear chan- delier or candelabra bulbs with an
Do not exceed 60 Watts per bulb.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce
13
