Fireplace Installation
WARNING: Ensure the power cord is not installed so that
it is pinched or against any sharp edges and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.
Fireplace Assembly
The only assembly required is to slide the Front Glass onto the fireplace and install hardware to keep it in place.
1.Remove fireplace and glass carefully from the carton, discard the plastic bag and foam packaging.
2.Remove the foam block from within the fireplace (Figure 1).
3.Using side cutters or scissors, cut and remove the two (2) cable ties as shown in Figure 1 and remove the cardboard that protects the Log Set Assembly.
4.Remove the right hand side Trim by removing three (3)
Phillips screws at the side of
Figure 1 | Figure 2 | Log Set |
| Foam | Assembly |
| Block |
|
|
| Front |
|
| Glass |
|
| Trim |
Cable |
| Track |
Ties |
|
|
|
| 7 |
