Maintenance
Figure 7 |
|
| Trim |
Log Set | Front |
Assembly | Glass |
the number of times you need to open the unit to replace light bulbs. Care must be taken when removing the Log set assembly as it contains LED’s and wires (DF2608 only).
1.Slide fireplace out of mantel.
2.Lay unit on it’s back for safe removal of front glass.
3.Remove three (3) Phillips screws from the right side of trim.
4.Remove trim.
5.Slide glass to right side of fireplace to remove (Figure 7).
6.Pull the front edge of the plastic ember bed or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the mirror (Figure 8).
!IMPORTANT: Only handle
Figure 8 | Log |
| |
| Ember Bed |
Back |
|
Ledge |
|
Rear |
|
Tab | Front |
Side Section | |
| Edge |
the log set assembly by the ember bed or plastic grate.
!NOTE: Log set assembly fits tightly into firebox, some force may be necessary to remove.
7.Set log set assembly in front of fireplace.
8.Remove flicker rod by pulling rod to the right, towards the flicker motor. Bend the flicker rod enough to clear the bracket on the left, lift out and pull flicker rod off of flicker motor shaft (Figure 9).
9.Remove four (4) Phillips screws (two (2) per side) which attach light filter bracket for easier access to light bulbs (Figure 9).
10.Unscrew bulbs counter clockwise to remove.
11.Insert new bulbs and screw in
14 | www.dimplex.com |
