REFERENCES 5
5.9.2 Copy Gryphon™ Mx30 Series
Procedure:
Using the slave reader and its OM-Gryphon™ cradle, follow the initialization
procedure in chapter 4 of this manual or from the Quick Reference Manual.
With the master Gryphon™ Mx30 (correctly configured reader), read the Copy
Configuration barcode below. Then place it onto an OM-Gryphon™ cradle within
10 seconds. The reader will beep indicating the configuration has been copied.
The configuration will be simultaneously sent over the RS232 interface of the
OM-Gryphon™. If this causes undesired effects disconnect the RS232 cable
between the PC and OM-Gryphon™ during this process.
Copy Configuration
Ì$+ZZ0$-*Î
With the slave Gryphon™ Mx30, read the Get Configuration barcode below.
Then place it onto the same OM-Gryphon™ cradle used in the step above. The
slave reader's address will not be changed.
Get Configuration
Ì$+ZZ2$-4Î
The configuration will be copied from the master to the slave Gryphon™ Mx30. he
slave Gryphon™ Mx30 signals the end of the procedure with a series of beeps. It is
now ready to be used with its own OM-Gryphon™ cradle.
Repeat the procedure above to configure other slave readers. The
OM-Gryphon™ can continue to configure slave readers until it receives another
command or data.
T
155