Dayton manual Dayton Propane Construction Heater, 3VG81 Specifications, Product Identification

Dayton Operating Instructions and Parts Manual 3VG81

Dayton® Propane

Construction Heater

3VG81 Specifications

Output Rating	150,000 Btu/Hr
Fuel	Propane Vapor Only
Fuel Consumption	7.0 Pounds/Hour (1.6 Gallons/Hour)
Regulator Input Pressure	Minimum:	10 Psig
	Maximum:	Tank Pressure
Regulator Output Pressure	12.5" WC (Factory Preset)
Manifold Pressure	9.8" WC (Factory Preset)
Ignition	Electronic direct spark, D.S.I.
Ignitor Gap	Minimum:	0.13"
	Maximum:	0.15"
Temperature Control	Built-In Thermostat
Air Flow	550 Cfm
Volts	120 Vac 60 Hz I Phase
Amps	2.2
Motor HP	1/8
Motor RPM	3,450
Dimensions	361/4"L x 20"H x 141/2"W
Heater Weight	27 Lb
Shipping Weight	35 Lb

Product Identification
	Handle
Hot Air Outlet	Upper Shell
(Front)
	Fan Guard

Lower Shell

Power

Cord

On/Off Switch

Thermostat

Knob

Inlet Connector

Hose/Regulator

Assembly

Figure 2 - Product Identification

General Safety Information

IMPORTANT: Make certain you read and understand all warnings. Keep these instructions for reference. They are your guide to safe and proper operation of this heater.

Safety information appears throughout these instructions. Pay close attention to them. Below are definitions for the safety information listed throughout this manual.

Under this heading, installation, operating

and maintenance procedures or practices will be found that, if not carefully followed, WILL result in IMMEDIATE serious personal injury or death.

Under this heading, installation, operat-

ing, and maintenance procedures or practices will be found that, if not carefully followed, COULD result in severe personal injury or death.

Under this heading, installation, oper-

ating, and maintenance procedures or practices will be found that, if not carefully followed, MAY result in minor personal injury, product or property damage.

IMPORTANT: Not every possible circum- stance that might involve a hazard can be anticipated. The warnings in this manual and on tags or decals affixed to the unit are therefore not all-inclusive. If a procedure, work method, or operating technique not specifi- cally recommended by Dayton is used, you must make sure it is safe for you and others. You should also ensure that equipment will not be damaged or made unsafe by the operating or maintenance method you choose.

2