DCS ADR36, ADR30, ADR48, ADR24 manual Installation, Make Cutout and Install Support Structure

INSTALLATION

MAKE CUTOUT AND INSTALL SUPPORT STRUCTURE

1. Make a cut-out in your cabinet or island with the following dimensions (Fig. 3):

Note:

The cutout of each corner should be 90º for the Access Drawers to fit properly.

Vent*

Vent*

		C
			Vent*
	A
90º			Optimal support
			locations

*Island installation to use minimum of 3 vents providing 10 sq. in. per vent (typical).

Fig. 3

CUTOUT DIMENSIONS

MODEL	A	B	C
	(+0,-1/8)	(+1/8,-0)
ADR48	46”	20”
ADR36	34”	20”	24-1/2” min.
ADR30	28”	20”	(all models)
ADR24	22”	20”

2.Place 2 X 4s to provide support for the Access Drawers structure in the locations indicated in the figure below (Fig. 4).

3.Board lengths are provided in the table below (Fig. 5).

To ensure proper drawer operation, be sure your support boards are flat & level.

B

8-3/4” 8-3/4”

A Optimal support locations.

C

SUPPORT BOARD DIMENSIONS

MODEL	A	B	C
48”	44”	1-1/2”	3-1/2”* min.
36”	32”	1-1/2”	3-1/2”* min.
30”	26”	1-1/2”	3-1/2”* min.
24”	20”	1-1/2”	3-1/2”* min.

*Dependent on application.

Fig. 4

4.When installing your support boards, be sure they are level.

5.Check to be certain that the top edges of your boards are level with the bottom edge of the cut-out (Fig. 6).

Fig. 5

Front View (typical) End View (typical)

For proper support & drawer operation, insure that support boards are level front to back & side to side.

Support Board (typical)

Support Boards (typical)

Fig. 6